Infusion set

Description
Infusion set.
Single-use, sterile, non-pyrogenic, latex-free, phthalate-free product.

Instructions for use
- Close the roller clamp on the connector.
- Remove the protector from the central diaphragm of the bottle cap and clean it with an antiseptic solution before piercing it.
- Hang the bottle.
- Remove the protector from the spike of the connector.
- Insert the spike with a rotating motion into the central depression of the cap.
- Squeeze and release the drip chamber to partially fill it.
- Remove the protector from the end (luer lock) of the connector and attach a sterile and non-pyrogenic intravenous infusion needle.
- Open the roller clamp, open the air filter vent, and fill the connector and needle with the solution. Remove any air bubbles.
- Close the roller clamp, remove the needle protector, and insert it into the vein.
- Adjust the administration rate with the roller clamp.
- Any medications can be added to the bottle solution by injecting them through the Y-connector.

Warnings
Do not use if the packaging is not intact and/or if the caps are damaged or detached. Discard after use with the precautions adopted for potentially contaminated material. Do not use with I.V. pumps. Do not use for blood and blood products. Do not reuse due to the risk of patient contamination. The product must be used by specialized medical and nursing personnel. Use the connector and needle immediately after removing the protectors.

Format
1 piece sachet.

Code. 7170